MicroBoards Technology MX SERIES Spezifikationen PDF herunterladen (Seite 9)

MICROBOARDS TECHNOLOGY, LLC MX DISC PUBLISHER

MX Disc Publisher Installation

The MX Disc Publisher installation disc includes an Installer that will walk you

through the process step by step. Please use the Installer and follow the

installation steps in order.

The following installation sections are intended only as a reference for the installation process, not as

a guide to installing the MX Disc Publisher. Performing the installation out of order could result in an

unsuccessful installation.

The MX Disc Publisher Installation Quick Reference Guide will show you the order in which the

installation will occur.

Installation should always be done when logged in as a user with full Administrator rights.

Windows Component Prerequisites

During the installation process, your PC will be checked to determine if 2 required Microsoft Windows

components are present. If not, these components will be installed. You cannot continue the

installation without installing these necessary Microsoft Windows components.

Connecting to a PC

DO NOT CONNECT YOUR MX PRINT FACTORY TO A COMPUTER BEFORE RUNNING

THE INSTALLER LOCATED ON THE INSTALLATION DISC!!

The connection between the PC and the Microboards MX Disc Publisher is with one USB cable.

1. Confirm that the power is turned OFF on the MX Disc Publisher and on your PC.

2. Plug in the AC power cord to the back of the MX Disc Publisher. Do not turn on power to the

MX Disc Publisher until all 4 ink cartridges and both printheads have been installed.

3. Connect the square shaped end of the USB cable to the back of the MX Disc Publisher.

4. Connect the flat, rectangular end of the USB cable into a USB 2.0 port in

your PC.

USB Cable length exceeding 6 feet between the MX Disc Publisher and the PC is

not supported!

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Keine Kommentare

MicroBoards Technology MX SERIES Spezifikationen Seite 9